Belkin F5D7230au4P User Manual download pdf (Page 131)

129

Troubleshooting

129

section

5. Select “TKIP” or “AES” under “Date Encryption”. This setting will

have to be identical to the Wireless Router or Access Point that

you set up.

6. Type in your encryption key in the “Network Key” box.

Important: Enter your Pre-Shared key. This can be from 8 to 63

characters and can be letters, numbers, or symbols. This same

key must be used on all of the clients that you set up.

7. Click “OK” to apply settings.

Problem:

I can’t print from one of the computers on my network. What do I do?

Solution:

For the PC to be able to print to the networked printer (printer on the print

server), the printer’s software and drivers must be installed on the PC.

Every manufacturer ships its printer with a driver and, usually, printing

software. Be sure that you have installed the printer drivers and software

on each PC from which you plan to print. In some cases, while installing the

drivers and software for your printer, you may be required to connect the

PC directly to the printer in order to complete the installation. This varies

according to manufacturer.

Problem:

I keep getting the error message, “Cannot find the Router” when running the

Print Server Wizard. What do I do?

Solution:

If the Print Server Wizard is not able to find the Print Server in the Router,

this means the computer does not have a valid connection to the Router. The

most common causes of this issue are:

1. Wired computers (those not connected wirelessly): Check the

cable between the computer and the Router. Make sure the light

on the front of the Router that corresponds with the port on the

back of the Router is lit. (If the computer is plugged into port 4,

make sure the light for port 4 is lit).

1 2 ... 126 127 128 129 130 131 132 133 134 135 136

No comments

Belkin F5D7230au4P User Manual Page 131