Belkin F1DP108Gea User Manual download pdf (Page 62)

Now that you have connected your console and servers to the Switch,

it is ready for use. You can select connected servers by using either the

front-panel port selectors, the On-Screen Display (OSD), or hot-key commands

through the console keyboard. It takes approximately 1–2 seconds for the video

signal to refresh after switching servers. Re-synchronization of the mouse and

keyboard signals also occurs. This is normal operation and ensures that proper

synchronization is established between the console and the connected servers.

Selecting a Server or BANK

Selecting a Server or BANK Using Hot Keys

Switch to the next or previous port with simple keyboard hot-key sequences

using the Scroll Lock key and either the up or down arrow keys. To send

commands to the Switch, the Scroll Lock key must be pressed twice within two

seconds. The Switch will beep, confirming that it is in hot-key mode. Next, press

the up arrow key and the Switch will switch to the next port. Press the down

arrow key to switch to the previous port.

With a single-switch configuration (no daisy-chained KVM switches), you can

switch directly to any port by entering the 2-digit number of the port you wish to

access. For example, if you press “Scroll Lock”, “Scroll Lock”, “02”, the Switch

will switch to the server on port 2 located on BANK 00.

Using the Switch from a Local Console

Switch to next active port, “Up” arrow.

Switch to previous active port,

“Down” arrow

Switch to BANK 00, Port 2 (02)

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 83 84

No comments

Belkin F1DP108Gea User Manual Page 62