Belkin F1DP108Gea User Manual download pdf (Page 61)

575757

section

Restoring Factory Defaults

The “Restore Factory Settings” section on page 42

explains how to restore

factory settings from the web interface. When you cannot access the system

(you have forgotten the user name, IP address, or password), you can restore

factory defaults from the Switch.

To restore factory defaults:

Press and hold down the “Go-Local” button on the back of the Switch

for five seconds while powering up the Switch. The Switch will boot

up in safe mode.

Wait 30 seconds for the Switch to reboot.

http://192.168.2.155/config

The blank login screen will appear (no background picture).

Note:

Do not start the IP address with

https

Note:

The IP address is only valid if DHCP is turned off and that is the

static address. If the IP is set to DHCP or a different Static IP address, a

different address than 192.168.2.155 will need to be used.

Type in the following default user name and password (case-

sensitive), and click “Login”. This user name and password only work

immediately after the reset procedure described above.

Safe-Mode User

Safe-Mode Password

admin

SAFEmode

From the menu, select “Restore Factory Settings”. A warning will

appear advising you that all device data will be erased.

Check the box if you would like to preserve network settings.

Click “Restore”. The factory defaults will be restored. When the

process finishes, you will be prompted to reboot.

Click “Reboot” to restart the Switch.

Using the Switch from a Remote Console

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

No comments

Belkin F1DP108Gea User Manual Page 61