Belkin OmniView User Manual download pdf (Page 7)

STEP-BY-STEP INSTALLATION GUIDE

Installing the HID USB Driver

Note: On some computers, you must enable USB support on your system

BIOS. Please reference your computer manufacturer’s manual or

motherboard manual to verify that USB support is enabled.

1. Connect the 9V, 1A power adapter to the KVM Switch.

2. Boot up the computer you wish to connect via USB as you would

normally with the USB keyboard, monitor, and USB mouse connected

directly to the computer.

3. After the operating system finishes loading, using a standard USB A-

to-B cable, insert the end with the B-type connector to the

KVM Switch. Insert the other end of the cable with the A-type

connector to an available port on your USB computer. Your computer

should recognize your KVM Switch and automatically install the HID

USB driver. Once the driver is installed, you can power down your

computer.

4. Repeat steps 1 through 3 for each additional USB computer you wish

to connect to the KVM Switch.

STEP-BY-STEP INSTALLATION GUIDE

Connecting the Console

1. Power down your computers.

2. Remove the rear panel of the KVM Switch to expose the

ports.

3. Connect the USB keyboard to the designated USB

port with the keyboard symbol on the KVM Switch.

Note: You must connect the USB

keyboard to the designated USB

connector to have keyboard

hot key switching functions.

For more information on

keyboard hot keys, see page 14.

4. Connect the USB mouse to

the designated USB port

with the mouse symbol

on the KVM Switch.

5. Connect any USB devices

you wish to share to the USB hub labeled “Device 1, Device 2” on the

KVM Switch.

Note: When sharing USB storage devices, CD-RWs, or hard drives, do not

switch while operating.

6. Connect the monitor cable to the designated

“Console VGA” port on the KVM Switch.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Belkin OmniView User Manual Page 7