Belkin F8T003V2SOFTWARE User's Guide download pdf (Page 57)

PAY@PC • User Guide and Tutorial • 2.00.0629.2009 page 53

Trouble-Shooting

Pairing the Merchant On The Go with a Bluetooth Device

To correctly pair the Merchant On The Go, follow these steps:

1. Full charge the Merchant On The Go.

2. Make sure there is paper in the Merchant On The Go.

3. If you are using a laptop, make sure it is plugged in or fully charged.

4. Reset the Merchant On The Go by:

a. Turning on the Merchant On The Go.

b. Turning over the Merchant On The Go and press the reset button using a thin paperclip or pin

– the small hole next to the battery compartment. This will turn off the Spectrum.

c. Pressing and Holding the On button for 3 seconds.

Once the diagnostic sheet prints out, the spectrum is ready for pairing

5. Start the pairing process by following the instructions that came with your computer or Bluetooth

adaptor. Note: Make sure to search for all devices.

6. Select the Merchant On The Go from the list of devices.

The device name (Bluetooth ID) should start with MSP.

The actually name will be printed on your diagnostic sheet next to B/T ID.

7. Enter the Passkey (see user manual)

8. Enter the service and assign a COM Port for the outgoing connection.

If an outgoing COM Port is already assigned, use that COM Port in PAY@PC.

If the Bluetooth Printer is not connected, then PAY@PC will not display the COM Port in the Device

Printer or Card Reader Settings.

1 2 ... 52 53 54 55 56 57 58

No comments

Belkin F8T003V2SOFTWARE User's Guide Page 57