Belkin F5U222V Datasheet download pdf (Page 2)

TMP3200/090 DATASHEET

Doc. No. 37061 Rev. J 2 of 6

System Setup

When designing a fixture, allow for 3-axis adjustment to aid in

horizontal, vertical, and lateral alignment of the marking head.

1. Mount marking head using four M6-1.00 x 20 mm bolts.

2. Mount filter/regulator assembly within 4 m (13 ft.) of marker.

3. Connect drive air and return air lines to the marking head.

4. Connect supply air to input port on filter/regulator assembly.

Note: The controller is not a sealed unit. Protect it from

potentially damaging conditions and contaminants. Do

not block case vents. Ensure the marking system is

electrically isolated from any devices that may generate

extreme electromagnetic interference (EMI).

5. Locate controller as close as practical to marking head.

Standard marker cable length is 4m (13 ft.).

6. Ensure controller and PC power switches are OFF.

7. Connect USB cable to controller and to PC.

8. Connect marker cable from marking head to controller.

TMP3200 Mounting Details

9. Connect power cables to controller and to PC.

10. Position PC power switch to ON.

11. For customer-supplied PC, install marking system software.

12. Position controller power switch to ON.

13. Start marking system software.

14. Adjust pin stroke, drive air, and return air for impact depth.

System Options

• Tool Post Assembly

• Marking Head Extension Cables

• Clip-on Cartridge Adapter Kit

• Theta (Rotational) Axis and/or Z (Vertical) Axis

• Bar Code Scanner or Bar Code Wand with Cable

• Foot Switch (Start Print) or Pushbutton Station (Start/Abort)

• Logo/Font Generator Software

1 2 3 4 5 6

No comments

Belkin F5U222V Datasheet Page 2