Belkin F5U252 User Manual download pdf

Technical Support Information

F5U252 USB 2.0 PCI Express Card Installation Guide

Below is a step by step guide for installing the F5U252, and then verifying the card is installed correctly using the

supplied drivers allowing it to function correctly.

Initial Installation

1. Unpack the card and the installation disk, DO NOT install the card into your pc at this time.

2. Insert the installation CD, a Belkin menu should automatically appear. If it does not then click “Start | Run” and

type “X:\autorun.exe” (With X being the drive letter of your CD drive).

3. Click “Install Driver”, the setup for the USB 2.0 driver should run and install the drivers onto your pc, if requested

reboot the computer.

4. Close the menu and shut down your computer.

5. Insert the F5U252 into an empty PCI Express slot and secure using the bracket or screws provided in your pc

case. Close the case and turn the computer back on.

6. Windows will install a number of hardware items automatically, allow it to do this and once completed you can

proceed to verifying the installation.

Verifying Installation – USB 2.0

1. The USB part of the card contains three components, two USB 1.1 controllers and 1 USB 2.0 controller. The

included manual’s explanation of how these devices should be installed is not entirely correct.

2. The USB 1.1 controllers should appear as either NEC PCI to USB Open Host Controller x 2 or Standard

Open HCD USB Host Controller x 2

3. Using either of these drivers is fine as they are both the same Microsoft driver simply named differently. So

firstly verify that you can see two entries of either of the above.

4. After allowing Windows to install the card automatically you will see the following,

Belkin Ltd Express Business Park Shipton Way Rushden England NN10 6GL | eurosupport@belkin.com | www.belkin.com

Page 1

1 2 3

Technical Support Information 1

Summary of Contents

Page 1 - Technical Support Information

Technical Support InformationF5U252 USB 2.0 PCI Express Card Installation GuideBelow is a step by step guide for installing the F5U252, and then verif

Page 2

Technical Support Information5. The manual states the USB 2.0 controller should be install as the “Standard Enhanced PCI to USB Host Controller”, this

Page 3

Technical Support Information5. Select “NEC PCI to USB Enhanced Host Controller” and click “Next”.6. Click “Finish”. The installation is now complete,