Installation der Hardwaren
22
C. Monitor
Zuerst müssen Sie die Auflösung bestimmen, die der Monitor unterstützt.
Setzen Sie dann die DIP-Schalter SW1 bis SW6 entsprechend der
Einstellungen für den jeweiligen Monitor. Weitere Informationen hierzu
siehe Tabelle 2.
• Die in der Tabelle gezeigten Einstellungen A und B sind für die meisten
Anwendungen zu empfehlen, bei denen die Auflösung im Macintosh
®
-Menü
unter "Kontrollfelder" > "Monitore" ausgewählt wird.
• Einstellung A ist die sicherste Einstellung für ältere SVGA-Monitore ohne
MultiSync (für VGA-Monitore nur Auflösung 640 x 480 möglich).
• Einstellung B wird für MultiSync-SVGA-Monitore empfohlen, da die
Bildwiederholrate hier höher ist.
Tabelle 2
Einstellung SW1 SW2 SW3 SW4 SW5 SW6 Zeilenfrequenz Bildwiederholrate Auflösung Bildschirmangaben
(kHz) (Hz)
A EIN EIN 31.5 60 640 x 480 VGA
EIN EIN 35.2 50 800 x 600 SVGA
B EIN EIN EIN 35 67 640 x 480 VGA
EIN EIN EIN 49 75 800 x 600 SVGA
C EIN 35 67 640 x 480 13” Farbmonitor
D EIN EIN 512 x 384
NTSC ((Flächenunterschreitung)
E EIN EIN 24.48 60.15 512 x 384 12” Farbmonitor
F EIN EIN EIN 68.7 75 1152 x 870 21” Farbmonitorr
GEIN 640 x 480
NTSC (Flächenüberschreitung)
H EIN 1152 x 870
21” Monochrom-Bildschirm
I EIN EIN 640 x 870
Hochformat
J EIN EIN 60.2 75 1024 x 768 19” Farbmonitor
K EIN EIN 49.7 75 832 x 624 16” Farbmonitor
L EIN EIN EIN 640 x 480 PAL
BITTE ÜBERPRÜFEN SIE SPEZIFIKATIONEN IHRES
MONITORS UND WÄHLEN SIE DIE KORREKTEN
EINSTELLUNGEN, BEVOR SIE DEN MONITOR EINSCHALTEN.
EINE FALSCHE EINSTELLUNG KANN DEM MONITOR EINEN
IRREPARABLEN SCHADEN ZUFÜGEN!
Comments to this Manuals